Page 2
WARNING: The child seat must only be installed in the rearward facing position. Please take a few moments to read this guide on how to use the BYGO ® WARNING: Never use the child seat without fastening it into the car as described in these fitting instructions, if the shoulder correctly so you can rest assured that your little one is safe and secure in height is not ok, please re-install the seat again.
Your Bygo Car Seat Contents ® Adjusting the shoulder straps The harness Correct shoulder height Fitting your car seat Installation Adjusting the handle positions Using with a travel system Care and maintenance Notes WARNING Do not remove the integral foam..
The Harness Adjusting the Shoulder Straps 1. Open the harness Buckle 1. Fastening the harness Press the red release button. Slot the two plastic sections of the buckle connectors together. Slot the two connectors into the hole in the top of the buckle until they ‘...
The Harness Correct Shoulder Height 1. Before the car seat is installed The harness should be adjusted as tightly as possi- ble without causing discomfort to the child. A loose in the vehicle harness is dangerous and should be checked each The harness has 2 positions.
Page 6
Fitting Your Car Seat Correct Installation 1. The type of approved 1. Installation of the car seat seat belt you must have Push the child seat facing rearward firmly against the Your child seat can only be installed rearward facing backrest of the cars seat.
Installation Installation 1. Ensure the car seat is correctly Take out all the slack in the seat belt, ensuring installed by checking the following that there are no twists or kinks in the seat belt. • The straps of the child safety seat are close to the body without contstricting the child •...
Adjusting the Handle Positions As a Travel System 1. Adjusting handle positions 1. Fitting the car seat to the chassis To adjust the handle from one position to another, First place the car seat adapters (supplied with the pull out both sides of the handle on the swivel car seat) onto the chassis, with the arrows facing point;...
As a Travel System Care and Maintenance Cleaning the shell Lift the car seat upwards from the handle. Use a damp cloth to clean the main body shell. Cleaning the belt lock and harness Use only a mild hand soap and warm water. Do not use chemical cleaners and never attempt to bleach or dye webbing.
Need help?
Do you have a question about the ByGo and is the answer not in the manual?
Questions and answers