Performing A Functional Test - Dometic MAGICWATCH MWE820 Installation And Operating Manual

MWE820, 860, 890
MWE890
I
NOTE
If the speedometer speed signal has been disconnected from the
control electronics, the default settings must be restored to ensure that
the sensors function correctly.
➤ Switch on the ignition.
➤ Press the button for longer than two seconds.
✓ The loudspeaker beeps repeatedly.
➤ Let go of the button.
✓ The system has been reset to the default settings.
9.4 Reflecting the display (MWE860 only)
If the obstacles are shown the wrong way round on the display, proceed as follows:
➤ Connect the sensor plugs into the sockets on the control module in the reverse
order (1 → 4, 2 → 3, 3 → 2, 4 → 1).
10

Performing a functional test

To test the parking aid, drive towards something slowly such as a wall.
A
NOTICE!
Be very careful when you operate the device for the first time, and make
sure that you familiarize yourself with the various sequences of beeps
(fig. d).
EN
Performing a functional test
11