Chatsworth Products CUBE-IT+ CABINET Installation Instructions

Download this manual

IIS-711890, SHEET 1 OF 4 - INSTALLATION INSTRUCTIONS, CUBE IT CABINET - 1:4 - 1-28-03 - ISS. 6 - CPI/BK

REMOVING REAR PANEL FROM CABINET

THIS STEP IS OPTIONAL, THE CABINET CAN BE

MOUNTED WITH THE REAR PANEL ATTACHED

STEP 1. DETERMINE WHICH SIDE THE CABINET WILL HINGE FROM. THE

CABINET IS SHOWN WITH THE HINGE ON THE LEFT SIDE, INVERT THE

CABINET IF YOU WANT THE HINGE ON THE RIGHT SIDE.

STEP 2. UNLOCK THE REAR FRAME AND OPEN IT TO GET ACCESS TO

THE HINGE BOLT NUTS.

STEP 3. REMOVE THE CENTER BOLT FROM THE BOTTOM HINGE ONLY.

LOOSEN THE OTHER TWO BOLT NUTS ON THE BOTTOM HINGE. DO

NOT REMOVE OR LOOSEN THE BOLTS ON THE TOP HINGE.

STEP 4. SLIDE THE BOTTOM HINGE PIN UP UNTIL THE LOOSENED

BOLTS REACH THE END OF THE SLOT. REMOVE THE REAR FRAME BY

MOVING THE BOTTOM OF THE FRAME TO THE REAR AND THEN

DOWNWARD TO DISENGAGE IT FROM THE TOP HINGE PLATE.

SLIDE HINGE PIN UP

TO END OF SLOTS

REMOVE CENTER NUT FROM

INSIDE THEN REMOVE BOLT

LOOSEN NUTS FROM

INSIDE, DO NOT

REMOVE BOLTS

DETAIL A

INSTALLATION

INSTRUCTIONS,

CUBE-IT+ CABINET

THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO

CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE

OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT

AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.

Page 1 REMOVE CENTER NUT FROM INSIDE THEN REMOVE BOLT INSTALLATION INSTRUCTIONS, CUBE-IT+ CABINET THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
Page 2 BACK-BOARD AND THEN INTO WOOD WALL STUDS. FOR MASONRY SURFACE, THE INSTALLER MUST THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE PROVIDE APPROPRIATE HARDWARE. OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
Page 3 INSURE THAT THE HINGE PIN DOES NOT SLIP DURING OPERATION THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.
Page 4 3. REINSTALL THE SCREWS AND NUTS ON THE OPPOSITE SIDE. CUBE-IT+ CABINET THIS DRAWING CONTAINS INFORMATION PROPRIETARY TO CHATSWORTH PRODUCTS, INC. ANY REPRODUCTION DISCLOSURE OR USE OF THIS DRAWING IS EXPRESSLY FORBIDDEN EXCEPT AS AGREED TO IN WRITING BY CHATSWORTH PRODUCTS, INC.