Advertisement
PRECAUTIONARY MEASURES
Important:
If the suction opening of the unit, the hose or the chrome telescopic tube
are BLOCKED, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
1.
Do not operate the vacuum
cleaner too close to heaters or
radiators.
2.
Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
3.
Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.
4.
When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
5.
Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
6.
Do not use without all filters and
paper dust bag in place.
Note:
This vacuum cleaner is equipped
with a plug and power cord that retract
automatically. If the cord or plug get
damaged, it must be replaced by a
qualified technician.
Warning:
Hold the plug when
rewinding the cord. Do not allow
the cord to whip when rewinding.
3
OPERATING INSTRUCTIONS
Flat & Upright Parking Position
Please note that your vacuum cleaner
can be conveniently placed in a space
saving vertical parking position.
For vertical parking position, place the
vacuum on its side and slide the
parking position bracket that is on the
telescopic tube into the parking
position support that is on the
underside of the vacuum. (Fig. 18)
TROUBLE SHOOTING GUIDE
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE REASON
1.
Hose, wand or inlet is
blocked.
Motor runs but no
2.
Check bag full indicator.
suction
3.
Hose clamp not assembled to
hose inlet properly.
1.
Cord twisted.
Cord does not
2.
Cord pulled out too far -
rewind
beyond "RED" mark.
1.
Not firmly plugged in.
2.
No electricity in wall outlet.
Cleaner won't run
3.
Blown fuse/tripped breaker.
4.
Motor thermostat may have
tripped.
1.
Rotating brush or elbow
Turbo brush does
obstructed.
not rotate or
2.
Hose obstructed.
rotates slowly
3.
Dust bags full.
4.
Filters need changing.
Parking
Position
Bracket
Parking
Position
Support
Fig. 18
POSSIBLE SOLUTION
1.
Check for blockage - remove it.
2.
If dust bag is full, replace dust
bag.
3.
Insert hose clamp into hose inlet
until "snap" locks for proper
assembly.
1.
Pull cord out, straighten and
rewind again.
2.
Holding the plug, press the
rewind button and try to rewind
again.
1.
Plug unit in firmly.
2.
Check fuse or breaker.
3.
Replace fuse/reset breaker.
4.
Allow unit to cool down before
trying to switch "ON" again.
1.
Clear obstrucitons.
2.
Clear obstruciton.
3.
Replace dust bag.
4.
Replace filters.
8
Advertisement
