Selve commeo Receive Connect Operating Instruction page 40

GB
commeo initial operation/Setting
Configuration using a transmitter without display
The status LED starts flashing green or red slowly. The transmitter
shows the first bit. The first bit is displayed by one flash. Use the UP
button to set the first bit to 1 (green status LED) and the DOWN
button to set it to 0 (red status LED). Pushing the STOP button calls
the next bit. The status LED shows the second bit; the status LED
flashes green or red 2 x in sequence. Every push of the STOP button
jumps forward one bit. The bit can be set as described above. The
frequency of flashing corresponds to the bit position.
After setting the last bit, pushing the STOP button leaves the CON-
FIGURATION mode. The status LED starts flashing orange. The
transmitter is in SELECT mode.
Operation
+
3 s
1 s
1 s
1 s
Status LED
green = 1
1 x
red = 0
green = 1
2 x
red = 0
green = 1
3 x
red = 0
orange
40
Setting
= green = 1
= red = 0
= green = 1
= red = 0
= green = 1
= red = 0