Advertisement
STEP 2B: MINI MOUNTING PLATE INSTALLATION INSTRUCTIONS
1
3
4 "
"A" MOUNTING POINT
FIGURE 11
Drill hole for bushing according to diagram.
4
FIGURE 14
Pass power cord through bushing and connect
to electrician-provided 18AWG in-wall rated
cable (recommended).
STEP 3: LIGHT TUBE INSTALLATIONS
The THIN Suspension fixture is designed with an innovative magnetic connection. Simply insert the light tubes into their sleeves for
electrical contact to be made.
1. Reconnect main power
2. Push following passthrough
and insert light tubes into
sleeve onto illuminated light
the power end. Push light
tubes. Add light tubes and
tubes in carefully until they
sleeves as needed according
illuminate.
to your segment
configuration.
WWW.JUNIPER-DESIGN.COM
THIN SUSPENSION INSTALLATION GUIDE
2
DRILL
1/2" HOLE
FOR BUSHING
Install using provided screws according
to diagram.
Low voltage wires
to LED driver
O-Rings
Light Tube
FIGURE 16
|
INFO@JUNIPER-DESIGN.COM
INSTALL AT "A"
MOUNTING POINTS ONLY
INSTALL AT "B" & "C"
MOUNTING POINTS
FIGURE 12
5
Screw grippers into ceiling posts. Adjust aircraft cable lengths as
needed. Press safety nut on gripper to release aircraft cable. Tighten
safety nut when finished. Do not cut extra aircraft cable until fixture is
fully assembled and desired suspension height is achieved.
3. Slide the end
4. Space the O-rings apart
sleeves onto the last
on the power sleeve along
set of light tubes.
the length of the cable to
constrain the power cord
to aircraft cable.
|
+1 347 799-2915
3
FIGURE 13
Partly unscrew safety nut
on gripper and feed
aircraft cables through.
FIGURE 15
CARE INSTRUCTIONS
Brass will patina over
time like other natural
metals and regular care
is required in order to
retain the quality finish of
your THIN fixture for years
to come.
Gently wipe with a damp
cloth to remove dirt,
dust, and fingerprints.
Do not use any chemical
cleaning solution.
Use indoors only.
|
68 33RD STREET, UNIT 11, BROOKLYN, NY 11232
4
Advertisement
