Deighton FORMATIC Instruction Manual page 8

3.1 Check the Formatic for transport damage and report any immediately to Deighton
Manufacturing Ltd.
3.2 Before Operating the machine:-
Remove any packaging material
Position the Formatic relative to any other equipment it is to connect with. Connect the
machine to the correct supply.
3.3 Step 1;
are aligned and push the drum completely home (if the form is not at the top you may
need to lift the ejector set over the cam). Fit the paper cam/guard over the drum on the
end of the shaft and secure with locking knob, cam cannot be removed without rotating
the hopper due to the safety pin located on each hopper (left hand thread).
(3) INSTALLATION PROCEDURE
Locate the selected drum onto the drive shaft ensuring that the keyways