Page 2
This product contains some codes from GPL. In compliance with GPL agreement, AirLive will publish the GPL codes on our website. Please go to www.airlive.com and go to the "Support->GPL" menu to download source code. All Trademarks are properties of their respective holders. AirLive SI-101 User Manual...
Page 3
When replacing old appliances with new once, the retailer is legally obligated to take back your old appliance for disposal at least for free of charge. AirLive SI-101 User Manual...
The device adopts the Z-Wave 500 series chip, when your Z-Wave network system is all made by Z-Wave 500 series devices. The network system will have the advantages as below. AirLive SI-101 User Manual...
2 is for light control, the device will send the “Basic Set” command to this group. And each group support 8 nodes maximum. Failed or success in add/remove the node ID can be viewed from Z-Wave Controller. AirLive SI-101 User Manual...
Both the 2 tamper keys are pressed over 5 seconds. The device will into the alarm state. In that state, if any one of the tamper keys be released, the device will unsolicited to send the report to the nodes in the group 1. AirLive SI-101 User Manual...
Page 9
Propose the setting differential value should not small than 10. Caution 2: If the configuration No.4 is setting to 0 or 100, this functionality is useless. AirLive SI-101 User Manual...
3 times to abort the NWI mode. 1.4.3. Wake When the device power on, the device will wake about 20 seconds. In this duration, the controller can communicate with the device. Normally the device is always sleeping to save the battery energy. AirLive SI-101 User Manual...
There is one function DIP switch in front of the device. Remove the front cover in the right top of the PCB, and also has mark “M1” and “M2” for two switch. Notice: SI-101 don't have DIP switch in hardware. Description Test Mode.
2. And delay a while to turn OFF the lighting equipment. The delay time is setting by the configuration NO. 9. Notice: When the tamper key of the back side is released, the device always in the “Test Mode”, no matter the DIP switches setting. AirLive SI-101 User Manual...
Hold the front cover and pull back Hold the front cover and pull up Replace the new battery and install the cover back. Put the front cover bottom to 1-1, and press down. Push the front cover top to 2-1. AirLive SI-101 User Manual...
The thicker tape won't let the tamper key pressed, so the sensor will enter the test mode, you may test if installed position is good or not by this way. AirLive SI-101 User Manual...
Notice: In none test mode, only the value in 1 to 99 will enable the illumination detected function and update the illumination value. 5(*) Operation Operation mode. Using bit to control. Mode Caution: The value is unsigned byte, the range is from 0x00 ~ 0xFF. AirLive SI-101 User Manual...
Page 16
Sensor Binary Report. Bit5: Disable Multi CC in auto report. (1:Disable, 0:Enable) Bit6: Disable to report battery state when the device triggered. (1:Disable, 0:Enable) Turn Off Light 8 seconds per tick, default tick is 4 (32 Time AirLive SI-101 User Manual...
Page 17
And when the temperature is over 140 degree Fahrenheit, it will continue report. Enable this functionality will cause some issue please see the detail in the “Temperature Report” section. The illumination differential to report. Illumination 0x63 0 means turn off this function. AirLive SI-101 User Manual...
Need help?
Do you have a question about the SI-101 and is the answer not in the manual?
Questions and answers