Leakage Checkpoints - Kenmore 153.586420 Use & Care Manual

A
F
Read this manual fi rst. Then before checking the water heater
make sure the electric supply has been turned "OFF", and never
turn the electric supply "on" before the tank is completely full
of water.
Use this guide to check a "Leaking" water heater. Many
suspected "Leakers" are not leaking tanks. Often the source of
the water can be found and corrected.
If you are not thoroughly familiar with electric codes, the water
heater, and safety practices, contact your local Sears Service
Center to check the water heater.

LEAKAGE CHECKPOINTS

D
B
A
C
E
G
E
H
Never use this water heater unless it is completely full of water.
To prevent damage to the tank and heating element, the tank
must be fi lled with water. The water must fl ow from the hot water
faucet before turning "ON" power.
A. *Condensation may be seen on pipes in humid weather or
pipe connections may be leaking.
B. Small amounts of water from the temperature-pressure
relief valve may be due to thermal expansion or high water
pressure in your area.
C. *The temperature-pressure relief valve may be leaking at the
tank fi tting.
D. The primary anode rod fi tting may be leaking.
E. The element may be leaking at the tank fi tting.
Turn electrical power "OFF", remove access panel and insulation
cap with handle. If leaking around element, follow proper draining
instructions and remove element. Reposition or replace gasket
on element. Place element into opening and tighten securely.
Then follow "Filling the Water Heater" instructions in the
"Installation Instructions" section.
F. Water from drain valve may be due to the valve being opened
slightly
G. *The drain valve may be leaking at the tank fi tting.
H. Water in the water heater bottom or on the fl oor may be
from condensation, loose connections or the temperature-
pressure relief valve. DO NOT replace the water heater until
a full inspection of all possible water sources is made and
necessary corrective steps taken.
Leakage from other appliances, water lines, or ground seepage
should also be checked.
Note: To check where threaded portion enters tank,
insert cotton swab between jacket opening and fi tting.
If cotton is wet, follow "Draining" instructions in the
"Service and Adjustment" section and then remove
fi tting. Put pipe dope or tefl on tape on the threads
and replace. Then follow "Filling the Water Heater"
instructions in the "Installation Instructions" section.
22