Table of Contents
Advertisement
AXIS T8331 PIR Motion Detector Series
Functions
Functions
I/O and Event Configuration
Below text applies to both AXIS T8331 and AXIS T8331-E.
This section contains information of I/O configuration and Events on the Camera. For more information and specifications about the
products I/O and Event functionality see the products User Manual available on www.axis.com
I/O Port Configuration
1. Go to Setup – System Options – Ports & Devices – I/O Ports
2. Set port 1 to Input (default)
3. Set Normal state is to Grounded circuit
4. Press Save
Note
• If the port is used in an event, it is not possible to switch between Input and Output until the event is changed or removed.
• It is only possible to manually set Input or Output if the camera provides two or more configurable I/O ports.
Event Configuration
1. Go to the Events setup page and select Action Rules.
2. Select Add.
3. Type in a name for the Action Rule.
4. Select Input Signal from the Trigger drop-down list.
-
Select Digital Input Port from the drop-down list below.
-
Select 1 or 2 from the drop-down list below.
-
Make sure Active: is set to Yes.
5. Select a value from the Schedule drop-down list (Always is selected by default) or manually set a value by select
New schedule.
6. Select an action from the Type drop-down list.
7. Press OK in order to save the Action Rule
The Action Rule will now be in the list of Action Rules.
Walk Test
It is recommended to perform a walk test after installation to confirm that the PIR sensor is working properly.
Before the test, make sure the PIR sensor is configured as below:
•
Set the photocell to DAY (default setting).
•
Set the Pulse count switch to TEST.
•
Set the LED switch to ON (default setting). This applies to AXIS T8331 only.
After the warmup period is completed (approximately 60 s), conduct a walk test by moving in the detection zone of the PIR sensor.
The LED lights when the PIR sensor detects a moving object.
4
Advertisement
Table of Contents
