Advertisement
2.2 JP1 Setting
PIN1/2
PIN3/4
ID1
SCSI ID Setting
SCSI ID PIN 1/2 PIN 3/4 PIN 5/6
ID = 0
OFF
ID = 1
ON
ID = 2
OFF
ID = 3
ON
ID = 4
OFF
ID = 5
ON
ID = 6
OFF
ID = 7
ON
2.3 Product installation
Before installing AEC-7732U, make sure the SCSI host adapter was
installed and operated correctly. And follow the instructions below to install.
Step 1 Take out AEC-7732U from the anti-static bag
Step 2 Remove the sticking paper on the holder of AEC-7732U (Fig.1)
Fig.1
Step 3 Align the AEC-7732U SATA connector to the SATA slot of ODD(Fig.2)
Step 4 Push the 4 corner of AEC-7732U to make sure it was properly stuck
on SATA ODD
Step 5 Place the SATA ODD with AEC-7732U on a desk and wait for 30
minutes before using
Step 6 Connect CN5 of AEC-7732U to the SCSI adapter via a SCSI cable.
The last device on the SCSI bus must be terminated with SCSI
terminator. Check the jumper setting to enable it.
Step 7 Connect CN1 of AEC-7732U directly to the power supply.
*If for any reason you need to remove AEC-7732U from the SATA ODD,
just unscrew the four screws on the AEC-7732U corners(Fig.3)
PIN5/6
ID2
ID4
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
ON
ON
ON
PIN7/8
PIN9/10
Reserved
TMP_ON
PIN 9/10 : Terminator Power
PIN 11/12 : Terminator
PIN 13 : LED(+)
ON OFF
PIN 14 : LED(-)
Fig.2
2
PIN11/12
PIN13/14
TM_ON
LED+/-
PIN14
12V
5V
LED(-)
Fig.3
JP1
PIN1
LED(+)
Advertisement
