Advertisement
SETTING
SENSOR PAIRING
Press "
into pairing mode. Pairing order : Left Front
Left Rear
Left front tire icon begin to ash.
TROUBLESHOOTING
1. Air leakage after sensor installation
The tire valves may not be universal standard, please check with the local workshop.
2. No tire data are displayed after completing installation
Ensure ACC is turned on.
3. Missing/lost sensor
Please purchase new sensor.
4. Sensor battery low
Please replace with battery CR1632.
5. Change of tire location
Please reprogram the corresponding sensors.
Note
1.
TPMS (Tire Pressure Monitoring System) is designed for monitoring tire irregularities.
Drive has responsibility to maintain tires regularly.
2.
Driver should react promptly once warning from this unit alerted.
3.
Blaupunkt does not guarantee or assumes liability for the loss of sensors.
4.
All sensors in this unit have been pre-set individually for each tire in the factory.
5.
Whenever the location of tire changed, the sensor must be reprogrammed.
6.
The display will turn o whenever the car is turned o .
" and "
" simultaneously for at least 5 seconds to enter
Right Rear.
Immediately get the sensor to learn the code and wait for
5-8 seconds.
Unscrew the sensor
When system receives the signal, you will hear "Bi- Bi- Bi-" which
Right Front
indicates successful sensor pairing.
Every time display ashes the next location, repeat steps 3-4 to
pair the rest of the sensors.
After the last tire (right rear) is paired with the sensor, the display
will return to the original interface.
6
(Sensor pairing are required only when the tires or
the sensors has switched location or be replaced)
Advertisement
