Charging; Pairing; Reconnecting To Paired Devices - MEE AUDIO Matrix Cinema User Manual

Charging
Connect micro‐USB cable to the charging port of the Matrix Cinema and a powered‐on computer or USB
charger.
Charge time is ~2 hours. The red charging indicator light will turn off once fully charged.
Low battery is indicated by a flashing red status indicator light and "battery low" voice notification every
five minutes.
Pairing
Power on the headphones. Press and hold the Multifunction button for about 5 seconds until you hear
the headset say "Ready to Pair" and the light flashes red and blue.
Note: the headphones will enter pairing mode automatically on first use or after a reset
Pairing (continued)
Open the Bluetooth menu on the device you wish to pair (usually located in Settings‐>Bluetooth). If
needed, select "search for devices", "add new device", or "refresh."
Pairing (continued)
Select "MEE audio Matrix Cinema" and allow pairing to complete. Use "0000" if a pin is required.
Visit the Bluetooth Support Page at MEEaudio.com/Bluetooth for additional Bluetooth pairing and setup
information
Note: It is only necessary to pair your heaphones once with each device.
Reconnecting to paired devices
The Matrix Cinema stores previously paired devices and reconnects automatically with the last paired
Bluetooth device that is powered on and within range. If the headset does not connect automatically,