Sony LSPX-PS1 Operating Instructions

Floor Stand
Operating Instructions
©2016 Sony Corporation
Printed in China
LSPX-PS1
Checking the contents
• Floor stand (1)
 Power cord connector
 Stand base
 Power cord
 Poles
• Wall strap (1) • Wall strap screw (1)
• Warranty (1) • Operating Instructions (this document) (1)
Use the AC adaptor supplied with the LSPX-P1 projector.
4-582-834-11(1)
 Mounting plate
 Charge contact
 Quick release
• Hex key (1.5 mm) (1)
Assembling
1
Assemble the poles and stand base in order of .
Take care not to pinch the power cord between the poles.
Route the power cord between two rubber feet under the stand base.
Preventing tipping over by securing to the
wall
1
Drive the wall strap screw (supplied) into a solid wall.
Drive the wall strap screw at a height of 70 cm (27
(31 1 / inches) above the floor.
2
2
From the mounting plate, pass the stand through the larger loop of
the wall strap (supplied).
3
Hook the smaller loop of the wall strap onto the wall strap screw.
/ inches) to 80 cm
5
8
Continued