Standby Mode Display - Beko BD 220 User Manual

Standby mode display

When the handset is not in use, the handset is in the standby
mode. The LCD will display as:
1 DECT 10:37
Where:
1: Handset assigned number
DECT: Handset name
10:37: Time of the day ( 10 AM, 37 minutes)
(ex : 23:37 : 11 PM, 37 minutes)
Note that, the clock and date should be set.
Note : When your phone encountered AC power failure, or
when you removed the AC adaptor, the clock
Upon power up, it will be automatically set the time to 00:00
and the date to 01/01. You need to set the correct
date when your base is power on.
If your PSTN provides FSK CID, your DECT phone clock will
automatically set the time and date when you receive CID from
the PSTN network. This will only work if your PSTN
connection can provide FSK CID with valid date and time
information.
When your phone handset is out of battery power, just put the
handset on the charge cradle on the base and the time and
date will be restored. There is no need to set again the time
and day.
will be inaccurate.
time and
- 10 -
If you register new handset of your phone, there is no need to
set the clock on the new handset. The Time and Date will
synchronized to all handsets.
Date on one handset, the changes will take effect on all
handsets.
If you changed the Time and