Sennheiser SH350 Instructions For Use Manual page 16

16
2. Connecting the headset to the battery pack
(except HMEC 352, HMEC 355 and HMEC 356)
The NoiseGard™ electronics of the HMEC 350, HMEC 355-C, HMEC 372, HMEC 450 and
HMDC 372 headsets can also be powered via the BP-04 battery pack (see
"Recommended accessories" on page 9). The battery pack can be operated either on
standard or rechargeable batteries (not included in the delivery). However, to ensure a
longer operating time, we would recommend using standard AA size alkaline
manganese batteries (IEC LR 6) or NiMH rechargeable batteries.
Inserting / replacing the the batteries
Open the cover of the battery compartment.
Insert four AA size alkaline-manganese batteries (IEC LR 6). Observe correct polarity
when inserting the batteries.
Close the cover of the battery compartment.
LED operation and battery status indication
The battery pack has two control LEDs.
Yellow LED: The battery pack is turned on and the battery capacity is sufficient.
Red LED: The batteries are low. Replace the batteries.