Making A Vacuum Tester - NVE 866 Challenger Series Owner's Manual

Making a Vacuum Tester _______________________________________

1. Procure a flange to mount on your four-way valve, a short 4"
pipe nipple, a 4" pipe cap and a vacuum gage.
2. Drill and tap a 1/4" N.P.T. thread in the pipe cap.
3. Assemble the flange, nipple, pipe cap and vacuum gage.
4. Remove a flange from the four-way valve on your pump.
5. Start the pump and confirm the location you have chosen to test
from is at vacuum.
6. Using the existing O-ring, fasten the testing flange to your pump.
7. Start your pump and read the vacuum level on the gauge.
20 | 866 Challenger Series www.fraserwoods.ca