Advertisement
PmodCLS™ Reference Manual
MD2, MD1, MD0
Any external power applied to the PmodCLS must be within 2.7V and 5.5V; if you are powering the Pmod from its
VCC pin, you must operate the Pmod at 3.3V in order for the on-board step-up switching regulator to work
correctly.
3
Physical Dimensions
The pins on the pin header are spaced 100 mil apart. The PCB is 1.8 inches long on the sides parallel to the pins on
the pin header and 3.8 inches long on the sides perpendicular to the pin header.
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Protocol
0,0,0
UART
0,0,1
UART
0,1,0
UART
0,1,1
UART
1,0,0
TWI
1,0,1
TWI
1,1,0
SPI
1,1,1
Specified in EEPROM
Table 3. Mode jumper configurations.
Details
2400 baud
4800 baud
9600 baud
Baud rate in EEPROM
Address: 0x48
Address in EEPROM
Specified in EEPROM
Page 3 of 3
Advertisement
