Philips 7.5ft Lighted Balsam Fir Quick Start Manual page 12

ASSEMBLY INSTRUCTIONS
1. Carefully remove all pieces from the box and lay out parts flat on the floor. Carefully remove all protective
wrapping from the parts, paying special attention to avoid cutting or damaging the parts. Before beginning tree
assembly please make sure all carton contents are present. A complete listing and diagram of contents are listed
on page 1. Do not attempt to assemble the tree if any parts are missing or damaged. Please contact our
customer service department for replacement parts before returning to store.
2. Take the Tree Stand (D) out and lay the stand in a flat area. Then slide
the locking disk downward and snap into place See Fig 1.
3. Remove the plastic pole protectors from the end of each tree
section before assembling and discard See Fig 2.
4. Insert Section (C) into the assembled Tree Stand (D). Make sure the pole is firmly
inserted into the stand. Locate the round female connector from Section (C) and place it
near the top of Section (C) by the center pole See Fig 3 for image of connectors.
5. Insert Section (B) into Section (C). Connect the male connector from Section (B) into the
female connector from Section (C). Secure the connection by tightening the collar on
the connector.
6. Locate the female plug from Section (B) and place it near the top of Section (B) by the
center pole.
7. Insert Section (A) into Section (B). Connect the male connector from Section (A) into the female connector from
Section (B). Secure the connection by tightening the collar on the connector.
8. Locate the male connector from the bottom of Section (C) and connect it to the female connector of the Control
Box (E). Secure the connection by tightening the collar on the connector. See Figure 3.
Note, the connectors have a polarity tab that must line up. Make sure to
secure all of the connections by tightening the collar on the connectors.
9. Plug the cord from the Control Box into the wall outlet. The entire tree
should now be lit and is pre-set to light function 10: Bi-Directional Chasing Multicolors.
Refer to the "Connect to the Illuminate
and use the app to control your tree lights. Additional information, full instructions and troubleshooting tips
can be accessed through the Help screen inside the Illuminate™ app. The Help screen can be accessed at
any time by tapping on the Menu button and selecting "Help" from the drop down menu.
10. Allow branches to fall into place or gently pull up and out. Please note that the Top Section (A) does not have
hinges like the Middle Section (B) and Bottom Section (C).
11. Begin to shape the branches working from the bottom of the tree to the top. Start with the tips closest to the tree's
center pole. Fan out branch tips, one to the right, one to the left and one at the center. Tips should be alternately
placed so that they do not line up one after another. For further shaping instruction, please see diagram below or
go to our website at www.seasonalspecialties.com.
Item #: 755712 & 758775
DPCI: 051 01 2039 & 051 01 3039
TM
App" instructions from the Quick Start Guide on how to set-up Wi-Fi
SAVE THESE INSTRUCTIONS
Page 3 of 7
Fig 1
Fig. 2
Fig. 3