Set The Alarm Timer; Set The Sleep Timer - Blackweb Sound Charge User Manual

Important:
- If no button is pressed for 15 seconds, the settings will be lost and you will need to start again.
• To display the clock time
- When you press the button, the clock time is displayed. Wait for a few seconds until the display returns to
the original display.

Set the Alarm Timer

You can set two alarms that go off at different times.
- Ensure that you have set the clock correctly.
1. Press and hold the
digits will ash.
2. Press the buttons on the remote control to set the required hour. Then press the
con rm the hour.
3. Press the buttons on the remote control to set the required minute. Then press the
con rm the minute.
4. Press the buttons on the remote control to select an alarm sound source: FM tuner or buzzer.
Then press the or
5. Press the buttons on the remote control to select the required volume, we recommend no less than 5 as a
minimum. Then press the
• Activate and Deactivate the Alarm Timer:
Press the or buttons repeatedly to activate or deactivate the timer.
If the timer is activated, [ AL 1 ] or [ AL 2 ] is displayed.
If the timer is deactivated, the [ AL 1 ] or [ AL 2 ] will disappear from the display on the front of the unit.
• Repeat Alarm:
You can press to adjust the interval to repeat alarm. When the alarm rings, press the SNOOZE button on
remote control. The alarm repeats ringing 9 minutes later.
• Stop Alarm Ring:
When the alarm rings, press the corresponding
settings remain.
• View the Alarm Settings:
Press the or buttons to view the alarm settings.

Set the Sleep Timer

This unit can switch to standby automatically after a set period of time.
1. Press the button on remote control repeatedly to select a set period of time (in minutes).
90 60 30 15
or buttons on remote control in standby mode for a few seconds and the hour
buttons to con rm.
or buttons to con rm.
00
or or button. The alarm stops, but the alarm
7
or buttons to
or buttons to