Preparing & Fitting The Water Closet - Wallgate CWC-80 series Product Manual

Product Manual Solid Surface WC Pans
• A 110mm Ø soil pipe should be provided for connection to the CWC. The soil pipe
can be connected to the tail on the CWC using a suitable connector such as
those made by McAlpine which Wallgate can supply as an optional extra.
• A mains cold water supply should be provided and terminated with a suitable
isolating tap for connection to the flushing device. Refer to the product
instructions of the flushing device for details of connection sizes and water supply
ratings for pressure & flow.
• Apertures or holes are required in the wall for the flush pipe & the wall fixing bolts
to the WC pan. Details of their position are shown on the relevant drawing
provided with the pan model type.
NOTE: A 1:1 scale template for drilling the holes is available on request.
5.3. Preparing & fitting the Water Closet
WARNING! The CWC Water Closets weigh more than 25Kg so a two-man lift is
recommended. Always use safe lifting procedures when lifting heavy loads.
For large installations of several water closets, an optional lifting hook is
available from Wallgate.
WARNING! To maintain the anti-ligature & anti-vandal properties of this
product it must be installed in line with the following points.
1. Ensure product fixings are correctly fitted as detailed in the following
instructions.
2. Ensure all fixings are tightened to the recommended torque as detailed in
the following instructions.
3. Seal the edges of the product to the wall using anti-pick hard set mastic,
examples of recommended types are:
Arbokol 1025, manufactured by Adshead Ratcliffe & Co Ltd (www.arbo.co.uk).
Sikadur 33 manufactured by SIKA Ltd (www.sika.co.uk)
1. Remove the CWC from its packaging and place carefully onto a protective sheet
on the floor such as cardboard to avoid damage to the base edges. Under no
circumstances should the CWC be knocked or dropped when placing onto the
floor as damage to the bottom rim edges may result.
Revision 12
9