Commissioning For Use - Wallgate CWC-80 series Product Manual

Product Manual Solid Surface WC Pans
11. Install the flushing device in accordance with the instructions provided with it.
Note that for a cistern type device it must be mounted at the correct height to its
base from floor level as shown on the installation drawing provided to ensure the
flush performance is not impaired.
12. An external overflow pipe for a cistern type flushing device may be required if the
flush valve type being used does not provide internal overflow into the WC pan.
13. Hinged type WC seats can be fitted to the appropriate model WC pan that
provides for seat fixing points (i.e.; CWC-80, CWC-81, CWC-151-SF). Fitting the
seat must be done in accordance with the instructions provided with the WC seat.
5.4.

Commissioning for use

To commission the CWC Water Closet:
1. Turn ON the water supply & check all around for leaks on the flushing
device & the pan water inlet & outlet connectors.
2. Depending upon which type of flushing device has been fitted; you will
need to refer to the instructions provided with it to ensure it is set correctly
to give the correct operation & performance.
3. Operate the flush and check that the toilet flush's satisfactorily.
4. Check again for any leaks as detailed in (a) above.
5. Ensure that on completion these instructions & those for the flushing
device & associated controls are passed onto the customer.
Revision 12
11