Required Tools; Speaker Wire; Maximum Length - PSB CS630 Owner's Manual

UNPACKING...
The packing materials are designed to protect the speaker from damage during transport. If visible or concealed damage occurs during handling,
please notify your authorized PSB dealer, or the shipping company that delivered your loudspeaker. We highly recommend retaining all packaging,
as it may be needed to transport the speakers in the future.

Required Tools

The following tools will be needed for typical installations:
• Tape measure
• Pencil, level
• Utility knife
• Wallboard saw (and extra blades)
• Screwdriver
• Drill, drill bits
• Fish tape or probe wire
• Flashlight
• Speaker wire of the appropriate length and gauge
In addition to the supplies and material listed above, paint and extra fine sandpaper may be necessary if you wish to change the colour of the grille
from the standard white finish.

Speaker Wire

If speaker wire is not yet installed, follow these guidelines for the correct speaker wire. If wires are installed, check to ensure each cable and length
of run meets the following standards:
Gauge
16 AWG (1.3mm )
2
14 AWG (2.1mm )
2
12 AWG (3.3mm )
2
NOTE: Leave at least 14" (36cm) of extra wire length at the speaker location to ease the installation.
Painting
WARNING: Construction dust or paint on the speaker drivers can negatively affect their performance and if significant, will void their warranty.
The grille is constructed of painted steel. It can be painted following standard painting practices and techniques. Prior to painting, remove the scrim
covering from the grille to avoid damaging the material. Apply as many coats of paint as needed (thinned slightly) to produce an even surface and
avoid blocking grille perforations. Please note that spraying will yield best results.
Let a painted grille dry thoroughly in a well-ventilated area before carefully reapplying the grille scrim with reusable adhesive and installing it on
the speaker.

Maximum Length

30 ft (9 m)
50 ft (15 m)
90 ft (27 m)
4