Sennheiser E W 300 IEM G2 Instructions For Use Manual page 16

14
The antenna mounts consist of:
2 BNC extension cables (screw-in BNC socket
2 washers
2 nuts
2 antenna holders (GA 3030 AM only)
4 screws (GA 3030 AM only)
To front mount the antenna of the
Screw the BNC socket
using the supplied washer and nut.
Connect the BNC connector
Slide the transmitter into the 19'' rack.
Secure the rack mount "ears" to the rack.
Connect the telescopic antenna
Pull the end cap to extend the telescopic antenna
To front mount the antennas of the
Unsecure the rack mount "ears"
Guide the BNC cables through the holes in the rack mount "ears" as shown
in the diagram on the left.
Screw the antenna holders to the BNC sockets
washers and nuts.
Secure the antenna holders to the handles of the twin transmitter using
two of the supplied screws respectively.
to BNC connector
SR 300 IEM G2 transmitter:
of the BNC extension cables to the blanking plate
to the BNC socket
to the BNC socket
SR 350 IEM G2 twin
from the rack.
)
on the transmitter.
.
.
transmitter:
using the supplied