Advertisement
ASSEMBLY
Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until
assembly is completed.
Assembly requires your own Phillips screwdriver
1.
To make assembly easier, read the
information above before you begin.
Attach the Backrest (3) to the Frame (1)
with four M6 x 16mm Screws (5).
2. Attach the Leg (2) to the Frame (1) with an
M10 x 57mm Bolt (12) and an M10 Locknut
(13). Do not overtighten the Locknut; the
Leg must pivot freely.
Insert the Adjustment Pin (14) into the Leg
(2) and the Frame (1). Rotate the
Adjustment Pin so that the bent end is
over the Frame.
3. Insert a Pad Tube (4) into the upper hole in
the Leg (2). Slide the two Small Foam Pads
(6) onto the Pad Tube.
Insert the Adjustment Foot (8) into the Leg
(2). Make sure that the warning decals
are in the indicated locations.
Insert the remaining Pad Tube (4) into the
lower hole in the Leg (2) and into one of the
holes in the Adjustment Foot (8). Then,
slide the two Large Foam Pads (7) onto the
Pad Tube.
All manuals and user guides at all-guides.com
1
2
14
3
4
and two adjustable wrenches
1
5
12
2
1
13
4
6
2
4
7
8
3
Wide
End
5
6
7
Warning Decals
.
Advertisement
