Val6 KBE5S Owner's Manual page 11

Remove the fuel cap and insert a suction
1
pump into the fuel tank.
2 Watch the fuel gauge while refueling. When
the gauge reaches the maximum level, stop
refueling.
■ Adjust the angle of the main unit
CAUTION
Prior to operation, loosen the knob bolt to
move and set the main heater unit at the
desired angle, and tighten the knob bolt
firmly.
The vertical angle of the radiation disk is
adjustable up to 20 degrees.
■ Connecting the Power Supply
CAUTION
1 Make sure that the operating switch is
"OFF" , then plug the heater's power plug
into approved,
extension cord.
2 Plug extension cord into standard 120 volt/
60 Hz, 3-prong grounded outlet.
• Do not adjust the angle of the main unit while the heater is plugged in, operating, or hot
to avoid severe burns and electric shock.
• Do not use an adapter to change the power plug or power outlet from grounded (3
prongs or inlets) to ungrounded (2 prongs or inlets) as this improperly overrides the
safety function in grounding the heater by the provided power plug. Also if the power
cord or plug need to be replaced, please be sure to replace it only with genuine or man-
ufacturer-approved replacement parts.
grounded, three-wire
3 Wipe off any fuel that has spilled onto the
fuel tank or elsewhere.
Replace the fuel cap and tighten it securely.
Do not operate the heater with a loose fuel
cap or without a fuel cap.
● KBE5S
20 degrees
Loosen
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 meters) long, use 18
AWG (0.75 mm
• 11 to 100 feet (3.3 to 30.5 meters) long,
use 16 AWG (1.0 mm
Extension Cord
● KBE5L
Tighten
20 degrees
2
) rated cord
2
) rated cord
AC Outlet
Connect
Grounded Power Pin
9