Environmental Protection; Symbols On The Product; Maintenance; Symbols In This Manual - Ryobi RC18150U Original Instruction

Hide thumbs

Table of Contents

should charge them until the green LED on the front of the

charger stays on.

If the charger does not charge the battery pack under

normal circumstances, return both the battery pack and

charger to your nearest Authorized Service Center for

electrical check.

■

Charge the battery pack only with the charger provided.

■

Make sure the power supply is normal household

voltage, 220V-240V, 50Hz, AC only.

■

Connect the charger to the power supply.

■

Place the battery pack in the charger aligning raised

rib on the battery pack with the groove in the charger.

■

Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

NOTE: After charging is complete, the green LED will

remain on until the battery pack is removed from the

charger or charger is disconnected from the power supply.

■

The battery pack will become slightly warm to touch

while charging. This is normal and does not indicate a

problem.

■

Do not place the charger and battery pack in an area

of extreme heat or cold. They will work best at normal

room temperature.

NOTE: The charger and battery pack should be placed

in a location where the temperature is more than 10°C

but less than 25°C.

■

When batteries become fully charged, unplug the

charger from the power supply and remove the battery

pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack

cool down for approximately 30 minutes before attempting

to recharge.

MAINTENANCE

■

If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

■

Remove the plug of the product from the power socket

when it is not in use or when cleaning it.

■

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to various types of commercial

solvents and may be damaged by their use. Use clean

cloth or soft brush to remove dirt, dust, etc.

■

Do not at any time let brake fluids, gasoline, petroleum

based products, penetrating oils, etc., come in contact

with plastic parts. They contain chemicals that can

damage, weaken or destroy plastic.

WARNING

Hazardous voltages are present within this product; do

not disassemble.

■

There are no user service or replacement parts inside

this product. In case of damage or failure please return

to your authorised Ryobi service centre for professional

repair.