Assembly; Loop Handle Installation; Mc-S (Straight Shaft Attachment) - Bushranger MT261 Owner's/Operator's Manual

Assembly

Loop Handle Installation

1. Place the loop handle and the bottom clamp on the shaft
approximately 28cm (11 inches) from the end of the stop
switch/ throttle trigger assembly.
2. Install the four screws and nuts. Tighten the screws evenly.
3. Reposition the loop handle up or down the shaft assembly
to the most comfortable position, but no closer than 23 cm
(9 inches) from the end of the stop switch/ throttle trigger
assembly.
4. Tighten the screws and nuts.

MC-S (Straight Shaft Attachment)

Installing Guard
POTENTIAL HAZARD
・ Foreign objects can be thrown by Multi-cutter.
WHAT CAN HAPPEN
・ Contact with thrown objects can cause personal injury.
HOW TO AVOID THE HAZARD
・ Never operate the Multi-cutter without the blade guard.
1. Fasten the string cutoff blade to the guard with M5×12
screws as shown.
2. Attach the guard to the shaft assembly with the two M5x30
screws and plate as shown.
Installing Trimmer Head
POTENTIAL HAZARD
・ If the cutting attachment is not adequately tightened, it
can come loose from the Straight Shaft Attachment
during use.
WHAT CAN HAPPEN
・ This may cause damage to property or personal injury.
HOW TO AVOID THE HAZARD
・ Make sure the cutting attachment head is securely fas-
tened to the attaching shaft in the gearcase.
1. Remove the blade bolt, the stabilizer and the clamping
washer from the attaching shaft out of the gearcase. (Keep
the blade bolt , the stabilizer and the clamping washer.)
Note: The blade bolt has left-hand thread.
2. Align the hole in the boss adapter with the guide slot in the
gearcase.
WARNING
WARNING
＿ 7 ＿
Loop Handle
Screw（4）
Bottom Clamp
Nut (4)
M5X30 Screw(2)
Gearcase
Plate
Hex Nut
String Cutoff Blade
Trimmer Head
Attaching
Shaft
Boss
Adapter
Gearcase
Shaft Assembly
Shaft Assembly
Guard
M5X12
Screw(2)
Trimmer Head
Adapter
Left-hand
thread
Hex Wrench
(3mm)