Table of Contents
Advertisement
Before starting
Fit new alkaline batteries in the DataSonde observing the correct polarity. The DrillTrack G2 Receiver
must be fitted with 6 x 1.5V'C' size alkaline (LR14) or 3 x 65/ND2161 Rechargeable Battery Packs. For
the correct battery type refer to the section on Radiodetection DataSondes in this user guide or the
relevant Technical specification.
Switch the DataView on and using the magnetic mounts, place it on the Drilling machine in a comfortable
viewing position for the Drilling machine operator.
Lock and secure the receiver antenna outriggers into position.
How to Setup the DrillTrack G2 Receiver.
The DrillTrack G2 Receiver Setup Menu allows the user to initially set the Receiver to the required
measurements.
While the Receiver is turned off, press and hold the
on and enter the Setup Menu.
Using the
and the
selected option and to go to the next screen.
Repeat this procedure for all the Setup Menu screens.
The following screens with options will be displayed in the Setup Menu:
-
Depth measurement in Metric or Imperial.
-
Tilt measurement in Percentage of grade or Degrees.
-
Resolution of tilt measurement: High 0.2 Low 0.5.
-
DataSonde Temperature measurement in Celsius or Fahrenheit.
Numeric signal strength Activated or Deactivated.
-
-
Type and frequency of DataSonde.
-
Locate orientation.
Borelogger System Activated or Deactivated.
-
DrillTrack G2 Operating Instructions
key to select the required option, and press the
key, then press the
key to switch the unit
key to confirm the
5-1
Advertisement
Table of Contents
