Setting Up The Printer; Loading A Roll Of Labels - SII 410 User Manual

Setting up the Printer

If the printer is not recogonized using the installation wizard, you will need to set up your
printer manually. To do so, follow these steps:
Prepare the roll of labels
1 Open the Smart Label printer software
2 Under the Label pull-down menu, select Printer Set-up
3 Select Add a printer
4 Select how your printer is connected and click Done.

Loading a Roll of Labels

Prepare the roll of labels
1 Remove the sticker from the beginning of the roll of labels.
Note: Make sure there is a black sensor mark on the label backing as shown on page 3.
2 If needed, cut between the labels to create a "leader."
Roll
Prepared end
If the end of the roll is not prepared as shown above, cut between the labels leaving as
much backing as possible on the end of the roll to act as a leader.
Load the roll of labels
1 Make sure the power cord is connected and
the printer is turned on. The green status light
should be flashing.
2 Lift the base of the label
cover and rotate it open.
Waste Roll
Cut here
Spindle
Label Cover
7