Highs And Lows Mode - Davis Instruments Vantage Pro Manual

For example, to select Barometric pressure units, activate the Barometric
presure by pushing BAR. Next, press and release the 2nd key, then press the
Graph / Units key. The units field will display millibars, millimeters, inches, or
hectoPascals. Repeating these steps cycles through all four selections. Stop
when the the desired unit appears.
Barometric Pressure: millibars (mb), millimeters (mm) and inches (in)
H L
I G H SA N D O W S
<!--This section doesn't jibe with Vantage Pro - because we don't know how the
alarms mode will work yet--!> The Vantage Pro records highs and lows for
many weather conditions. All highs and lows represent the maximum or mini-
mum reading since the last time you cleared each individual high/low register.
If you have enabled the AutoClear for a particular high/low (see "Enabling/
Disabling AutoClear" on page 51), this reading will represent the high/low
since the time of the AutoClear. In other words, it will track highs and lows
over a 24 hour period. If you do not use AutoClear, you may track daily,
weekly, monthly, or yearly values, depending on how often you manually clear
them.
For most highs and lows, the time and date at which they occurred is stored
along with the value. Please note, however, that the date is only stored as long
as it falls within 14 days of the current date. After 14 days, the Vantage Pro dis-
plays only the high/low reading and the time; the date appears as a series of
dashes.
<!--Using Barometric Pressure not yet written --!>
Note: (
metric pressure.
Vantage Pro Console Manual
M
O D E

Highs and Lows Mode

for details on the stored baro-
Page 25