DAVIS Wheel-a-Weigh 1482 Standart Instruction Manual

7.
DRILL FOUR 3/16" (5 mm) HOLES through the tran-
som for attaching the pivot bracket.
8.
AFFIX PIVOT BRACKET. 3/16" (5 mm) machine
screws and hex nuts are provided in the parts kit, as
are a nylon spacer and backing plates for inside the
transom. Apply sealant behind spacer. Assemble
parts as shown below.
Pivot Nylon Backing
Machine
Bracket Spacer Sealant
Screws
ONE-YEAR WARRANTY
We warrant our products to be free of defects in material
and workmanship for one year from the date of original pur-
chase. Write for full warranty details.
This warranty does not apply to product which has been
used on loads weighing more than 220 pounds (100 kg).
9.
ATTACH WHEELS. With both pivot brackets installed,
the wheel frames can now be fastened with the
detent pins.
Plates
Hex Nuts
Detent Pin
(8 mm,
Stainless Steel)
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
info@davisnet.com
For information about our other fine products,
visit www.davisnet.com
PAGE 4
INSTALLED ON ALUMINUM BOAT
WHEEL UP
01482.010 July 2016
LAUNCHING WHEELS
This product is not designed to be used on loads over 220 lbs. (100 kg).
CARRYING THE BOAT
Wheel-a-Weigh transom wheels are portable and removable.
Detent Pin
A detent pin on each pivot bracket lets you position the
wheels up or down, or remove them completely for storage.
WHEEL DOWN WHEEL REMOVED
TOOLS NEEDED FOR INSTALLATION
Phillips Head Screwdriver
PAGE 1
#1482
STANDARD
INSTALLED ON HARD TRANSOM
INFLATABLE BOAT
In most cases, you can operate the
craft without removing the wheels.
CAUTION: This product
is not designed to be
towed behind a vehicle.
Damage may occur and
will void the warranty.
Tape Measure
Square
Drill with
3/16" (5 mm) Bit
Removable Tape
Sealant
8 mm Hex Wrench or
Pencil or Marking Pen
Crescent Wrench