Connect the WIT100 Sensor Digital bus line with a TE770340 / TE350628 connector to the bellow drivers and interface module:
•
Connected Indoor Driver (CID): limited compatibility to allow proper operation of fixture (OFF, backround level dim and task level lighting)
and OTA
•
Philips Sensor Ready driver (SR): compatibility desirable but not required
•
Leedarson 0-10V/DALI interface module: ON/OFF and dimming commands only (no Fault Reporting, no VLC, no Dimming Curve Change,
no 1% diming, partial UL924)
Cable from Driver/Interface module
www.currentbyge.com
All trademarks are the property of their respective owners. Information provided is subject to change without notice. All values are design or typical values