Antenna Installation - Kaval BDA1250 Manual

BDA1250

5 Antenna Installation

l All Antenna Installation is to be performed by Qualified Technical Personnel
only.
l Antenna Installation Instructions and locations below are for the purpose of
satisfying FCC RF Exposure Compliance requirements.
l The Roof Top Antenna for linking to the Donor Site is a directional (high gain)
Antenna fixed-mounted physically on the side or top of a building, or on a tower. The
Antenna Gain must be no more than 10 dBi. The Roof Top Antenna location should be
such that only Qualified Technical Personnel can access it, and that under normal
operating conditions no other person can touch the Antenna, or approach within 10
meters of the Antenna.
l The In-Building Antenna connection is via a coaxial cable distribution system with
Signal Taps at various points connected to the fixed-mounted Indoor Antennae. This
is shown in the figure in the Introduction. The Indoor Antennae are simple 1/4
Wavelength (0 dBi Gain) types. They are used with Kaval 12, 16, or 20 dB Cable
Taps. As such the maximum EIRP will be at the first Tapped Antenna, which will be
12 dB below the maximum signal level of the BDA1250; +28 dBm, or 0.63 Watts
EIRP. These Antennae are to be installed such that no person can touch the Antenna,
or approach within 0.2 Meters.
ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED TECHNICAL
PERSONNEL ONLY.
ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE PURPOSE
OF SATISFYING FCC RF EXPOSURE COMPLIANCE REQUIREMENTS, AND ARE NOT
OPTIONAL.
ALL ROOF TOP ANTENNA INSTALLATION MUST BE SUCH THAT NO PERSON CAN
TOUCH THE ANTENNA, OR APPROACH CLOSER THAN 10 METERS.
ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO PERSON
CAN TOUCH THE ANTENNAE, OR APPROACH CLOSER THAN 0.2 METERS.
DCM000000013
ANTENNA INSTALLATION
WARNING
© Kaval Telecom Inc
Equipment Manual
Page 14 of 17