Table of Contents
Advertisement
BDA1250
Power Switch
LED
To Outdoor
Antenna
4.4 Connecting the Power Cables
BDA1250 comes with AC adapter. Therefore an AC outlet providing 120 AC should be
available with 4ft of the BDA1250. If AC outlet is to be installed, it is highly recommended
that AC Power Wiring be performed by a qualified Electrician so as to ensure compliance
with all National and Local Electrical Wiring Regulations. Connecting power cables can be
done as follow:
1.
Locate the on/off switch on the front of the BDA1250. Turn the switch to the OFF
position.
2.
Locate a nearby AC outlet and connect AC adapter to the AC outlet.
3.
Connect the DC input jack of the AC adapter to the BDA12500.
4.
Make sure the adapter cable is neatly tugged away.
5.
Turn the BDA1250 power switch to the ON position. LED should be luminous to
indicate the present of power.
DCM000000013
DC Port
© Kaval Telecom Inc
Equipment Manual
Figure 3-2. RF and DC Connections
To Indoor
Antenna
Page 13 of 17
Advertisement
Table of Contents
