Table of Contents
Advertisement
PRECAUTIONS
Safety precautions
DANGER:
This VCR contains live parts. Do not remove
the cabinet.
WARNING:
To prevent fire or shock hazard, do not
expose this product to rain or moisture,
CAUTION:
Do not put your hand or other objects in the
cassette loading slot because of the risk of
injury or an accident. Be sure to keep small
children away from the VCR.
Caution concerning condensation
Be careful
of condensation
Condensation
can form inside a VCR when it
is suddenly moved from a cold place to a
warm, humid one, or when a heater has been
turned on to quickly heat the room.
Do not inserl a video cassette
if you use
this VCR in areas subject
to condensation.
Wait for 1-1/2 to 2 hours to completely
eliminate
condensation
before using the
VCR.
Operating precautions
Place the VCR on a flat, stable, level
surface. Never subject it to violent shaking
or any other shock or impact,
Do not expose the unit to high
temperatures.
Excessive heat (heat
sources such as heaters, ovens, closed car
on hot days, etc.) may damage the unit.
Be sure to use this VCR only in a
temperature
range of 5°C to 40°C (41 'F to
105°F) and at less than 80% humidity.
Do not use the unit under the following
conditions:
– in locations with high humidity
in presence of excessive dirt or dust
in areas subject to strong vibrations
near strong magnetic fields (e.g.
transmitting
antennas, motors,
fluorescent lights, etc.)
Do not stack anything on top of your VCR,
or block the air vents, to prevent damaging
or overheating.
Do not place anything, except VHS video
cassette tapes, in the unit.
Do not allow rain, steam, dew, salt water,
sand, oily smoke, metal objects, etc. to
enter the unit.
Clean with a dry and soft cloth, or soft cloth
slightly moistened with a mild detergent
solution.
Do not use any type of solvent, such as
alcohol or benzine.
Power
precautions
Do not forget that even in the stand-by
there is an electrical voltage inside the VCR
as long as it is connected to a wall socket.
Disconnect the power cord from the wall
socket if the VCR is not to be used for a
long time.
INTRODUCTION
Only cassettes marked ~
can
be used with this VCR.
Note:
If the unit does not operate
properly, switch it off, refer to
"TROUBLESHOOTING" o r contact
your Sanyo authorized service
agent.
Power
on/stand-by
mode
The power on ( I )/stand-by ((!))
mode is selected by pressing the
0/1 button.
VCRdisplay
Poweron
mode (1)
Stand-by mode (0)
'Stand-by mode" is the condition
n which only the time is
displayed,
4
Advertisement
Table of Contents
