SUPERTOOTH TW-1 User Manual

CHARGE:

1. Put the earpiece in the charging case.
(Note: Each earpiece should be placed in its respective slots; Left earpiece on left side marked "L" &
Right earpiece on right side marked "R")
2. Close the charging case.
3. Connect a micro-USB cable into the device socket of the Charging case.
Note: the charging case has an internal battery and can charge the TW1 even without
USB cable connected.

TW1 LED INDICATOR:

The LED will turn
The LED will turn OFF once the battery is fully charged.

CHARGING CASE LED INDICATOR:

GREEN: Battery Full
RED: Battery Low or charging

TURNING ON / OFF:

TW1 is in its charging case:
POWER ON:
Just Pick up the Earpiece from the charging case to turn ON automatically, Led turns
blinking GREEN within 3sec...
POWER OFF:
Put the Earpiece into the charging case and close to turn OFF automatically, Led
turns RED.
TW1 set alone:
POWER ON:
Long Press MFB for 2 seconds until LED is blinking
be heard. Do the same on the second unit.
NOTE: Turn ON the second unit; it will automatically reconnect to the paired earpiece.
POWER OFF:
Long Press MFB button until Led turns
Note: Turn OFF any of the 2 paired units will also turn OFF the other paired unit.

PAIRING TW1 TO A BLUETOOTH MOBILE PHONE:

(Pairing must be done first time only)
1. Remove the two earpieces from the charging case.
USER MANUAL
red while charging.
TW-1
RED and descending beep will be heard.
GREEN and ascending tone can