Kenmore 153.592500 Use & Care Manual page 23

DIAGNOSTIC CODES
WARNING! Electric Shock Hazard; Disconnect power before servicing. Do not remove the plac c guard from over wiring. Do not
touch electrical wiring. Failure to do so can result in death or electrical shock.
* EoF
* ECL
EEE
* ECC
ECE
NOTE: The diagnostic codes listed above are the most common. If a diagnostic code not listed above is displayed, call Sears Parts &
Repair Service Center at 1-800-488-1222 for further assistance.
*
There may be an audible alarm associated with this error. To cancel the audible alarm, press any bu on on the UIM.
Condensate management
Heat pump suction pressure is
too low.
EEPROM failure
Heat pump compressor is not
functioning
Power supply error.
Residen al Hybrid Electric Heat Pump Water Heater Use and Care Guide • 23
1. Ensure unit is installed level.
2. Check for blocked primary or secondary condensate drain
lines, clear drain lines as necessary.
3. If an accessory condensate pump was installed: Turn off
power to the water heater at the breaker and check control
wire connections to condensate pump. See "Connecting
Condensate Pump" page 13.
4. Check to see if the accessory condensate pump is plugged in
and has power.
5. Ensure the pump is operating properly, check pump outlet
tube for blockage.
6. Repair or replace accessory condensate pump as necessary.
7. If problem persists, call Sears Parts & Repair Service Center at
1-800-488-1222 for further assistance.
Call Sears Parts & Repair Service Center at 1-800-488-1222 for
further assistance.
1. Power cycle unit, see page 28.
2. If problem persists, call the Sears Parts & Repair Service Center
at 1-800-488-1222 for further assistance.
Call Sears Parts & Repair Service Center at 1-800-488-1222 for
further assistance.
Call Sears Parts & Repair Service Center at 1-800-488-1222 for
further assistance.