Override Function/Using The Remote Control(556Ftra Only) - Rinnai RHFE-556FA Owner's Operation And Installation Manual

/J . . . . .
'.
J
_ _ _ _ O_V_E_R_R_ID_, E_F_U_N_C_T_IO_N
---Jtg
""-
This function is intended to be used to manually override the current operation of the heater, For "
example; if the heater is in standby mode (Le. between finishing time and starting time of a Timer), I
and the Override button is selected, then the heater will begin to operate, and heat the room.
_~
IT]
~
To operate the Override simply press
~~l
I
-
..
-
the Override button. The Override
Timer 1 Timer 2 Override
Set Room
indicator will flash.
[Q]ro]~ ~ Te~pe§l
l \
Time ,
"' "
rn
0
AM[
I
-
To manually deactivate the Override simply
Timer 1 Timer 2 Override
PM
Set Room
press the Override button again. The Override
[Q][Q]~ (g
~~::~J
indicator will go out, and the heater will return to
'",-
standby mode.
The heater will continue to operate on Override until the Override button is pressed again, or one
of the Timers takes over the operation of the appliance. This means that the Override mode will
I
automatically drop out if a programmed Starting time is reached. The appliance will then return to
operating at times programmed into the Timer(s).
,m
THE REMOTE CONTROL
To Turn ON or OFF
To Change Temperature
Remote Control will not turn heater
ON if Timer(s) have been selected.
If the Timer(s) have been selected, and the heater is in standby mode, and the OFF button on the
Remote Control is pressed, the Timer(s) will be deactivated.
To manually operate
when Timer(s) are not
selected, simply press
the ON or OFF button.
To alter the
temperature at any
time while the heater is
operating, simply press
the "...."or
"T"
buttons.
@
A
)
'J
/--'j
!,J
-36-