Chamberlain KLIK2U Manual page 4

Programming
TYPE 2
Genie, Linear and Moore-O-Matic garage
door openers or receivers with:
DIP switches.
1 Select and write a 4-digit PIN:
__ __ __ __
2 Determine your opener ID using the list below.
ID DIP Switch Type
13 12 DIP switch Genie garage door openers
14 10 DIP switch Linear garage door openers
16 10 DIP switch Stanley garage door openers
17 9 DIP switch Genie garage door openers
18 8 DIP switch Linear, Moore-O-Matic garage door
openers
3 Record your DIP switch sequence. If DIP switch is in the "on" or "up"
position place a 1, "off" or "down" position place a 2 in the corresponding
box in the chart below: NOTE: Leave any unused switch locations blank.
DIP Switch
1 2 3 4 5 6 7 8 9 10 11 12
Sequence
ON
OFF
Opener
2 position
Remote Control
ON
4 Press and hold the
stops flashing.
ON
5 Enter PIN
6 Enter ID
7 Enter DIP
3 and press
8 To test and use, wait until
lights turn off, enter your
and press the
If opener does not function, flip DIP switches, so if a switch is "on" or "up"
flip it "off" or "down" in step 3.
4
* and # buttons until keypad
from step 1, press #.
from step 2, press #.
switch sequence from step
# key.
PIN
0 key.