Bosch SGE53X52UC Operating Instructions Manual page 32

en-us Operating the Dishwasher
Time display
When a wash cycle is selected the
remaining wash cycle time is shown
on the display 8.
The wash cycle time is determined
during the wash cycle by the water
temperature, the amount of dishes,
as well as the degree of soiling and
may vary (depending on the selected
wash cycle).
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
œ:‹‚ 1 hour delay
œ:ƒ... 24 hours delay
To set Delay start:
Press On/Off button (. Select a
1.
cycle.
Press Delay button @ until the
2.
displayed time corresponds with
your requirements.
Press Start button P to activate
3.
Delay start.
To cancel Delay start:
Press Delay button @ until œ:‹‹
1.
is indicated on the digital
display 8.
Press Start button P to save
2.
setting.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
32
Wash cycle end
The wash cycle has ended when the
display 8 reads ‹:‹‹.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete. To save energy the
recommended setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To change the setting:
Press the On/Off button (.
1.
Hold down the function key #
2.
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
Release both buttons.
3.
Press the function key # until
4.
the display 8 indicates ˜:‹x.
Press the function key 3 until
5.
the display corresponds with your
requirements.
Press the Start button P.
6.