Kenmore 11682 Owner's Manual page 38

SECTION 4. PERFORMANCE PROBLEMS CHART
What to Do When
PROBLEM PROBABLE CAUSE CORRECTION
Irregular Stitches
Breaking Needle
Bunching of Thread
Puckering
Incorrect size needle.
Improper threading.
Loose upper thread tension.
Pulling fabric.
Loose presser foot.
Unevenly wound bobbin,
Nicks or burrs at hole of needle plate.
Choose correct size needle for thread and fabric.
Rethread machine,
Tighten upper thread tension.
Do not pull fabric; guide it gently.
Reset presser foot.
Rewind bobbin.
Replace needle plate, or polish off burrs completely.
Pulling fabric.
Incorrect size needle.
Incorrect setting of needle.
Loose presser foot.
Upper and lower threads not drawn back
under presser foot before starting seam.
Incorrect thread tension(s).
Using two different sizes or kinds of thread.
Bent or blunt needle.
Loose presser foot.
Fabric very sheer or very soft.
Do not pull fabric; guide it gently.
Choose correct size needle for thread and fabric.
Reset needle,
Reset presser foot.
When starting a seam be sure to draw both threads under and
back of presser foot about 4" and hold until a few sdtchs are
formed.
Reset thread tension(s).
Upper thread and bobbin thread should be same size and kind.
Insert new needle.
Reset presser foot.
Use underlay of tissue paper.
34