Related Manuals for kincrome K12132
Summary of Contents for kincrome K12132
- Page 1 AIR/HYDRAULIC TRUCK JACK K12132 ED1 (July 16) Caution: Do not allow persons to operate or assemble this jack until they have read this manual and developed a thorough understanding on how the jack works...
-
Page 2: Table Of Contents
10. Saddle (Ø48x60mm) 11. Saddle (Ø68x25mm) 12. Saddle (Ø48x100mm) 13. Air Valve Assembly 14. Air Inlet SPECIFICATION Model No ............K12132 Lifting Capacity ..........22 Tonne Maximum Height........... 435mm *without Saddles Minimum Height: ......... 230mm Head Cap Diameter: 9. Ø 45x20mm ..10.Ø48x60mm ..11. Ø68x25mm ..12. Ø48x100mm Ram Travel ........... -
Page 3: General Safety Warnings
AIR/HYDRAULIC TRUCK JACK General Safety Warnings Save all warnings and instructions for future reference. WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in serious injury or death. IMPORTANT SAFETY INFORMATION The use of a vehicle jack has inherent dangers. To avoid risk of personal injury or property damage, make sure you are fully aware of the operating instructions for this product, the recommendations in the vehicle owners manual for jacking of your vehicle, prior to lifting the vehicle. - Page 4 AIR/HYDRAULIC TRUCK JACK Personal Safety Stay alert. Watch what you are doing and use common sense when operating the tool. Do not use the tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating the tool, increases the risk of injury to persons.
-
Page 5: Assembly
AIR/HYDRAULIC TRUCK JACK ASSEMBLY Remove the bolt from under the handle yoke (Fig 1). Insert the locking rod (4) with spring and washer through the handle yoke guide located on the lower handle tube. (Fig 2). Insert the lower handle tube in the handle yoke while simultaneously inserting the locking rod in the handle yoke guide holes (Fig 3). -
Page 6: Operation
Then, chock the wheels that are not being lifted. Caution: If an automatic oiler system is not used, add 3-4 drops of Kincrome Air Tool Oil to the air inlet (14) before operation. Add 1-2 more drops every hour of continual use. -
Page 7: Care & Maintenance
Remove the Oil Filler Plug (Fig 16) and keep it clean. d) Fill Reservoir with Kincrome hydraulic jack oil, (K12400) to the lower rim of the oil fill hole. e) Purge air from the hydraulic system as previously described on PURGING AIR FROM THE HYDRAULIC SYSTEM on page 4. -
Page 8: Troubleshooting
1. Release Knob (1) not fully closed. 1. Close Release Knob (1) firmly. 2. Overload condition 2. Remedy overload condition 3. Hydraulic unit malfunction 3. Contact Kincrome customer Service Jack will not lift smoothly or to 1. Oil level low. 1.Top-up to correct level. full height. -
Page 9: Warranty
(12 months) commences on the date that the product is purchased. If this product has materials or workmanship defects (other than defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement. - Page 10 www.kincrome.com.au...
Need help?
Do you have a question about the K12132 and is the answer not in the manual?
Questions and answers