Vakoss EK-H268 Instruction Manual

English
1. About the product
- Mini-sized, curved, aesthetic and luxurious. Conveniently cleanable, and absolutely
hygienic.
EK-H268
- The component temperature control used by the electric kettle utilizes international high
technology appliance standards, and food-grade plastic in compliance with international
Electric Kettle
hygiene standards. The new component temperature control automatically cuts power
Instruction Manual once the water has boiled.
- The electric kettle will automatically cut power when the kettle boils dry, making it safe
and reliable.
- The electric kettle offers true boiled water, good for one's health and which meets the
needs of hot water and tea drinkers.
- Quickly boil water within 5 or 10 minutes. Save time, satisfy the high-paced needs of your
family, office, or meeting room.
2. Component part names
kettle body
power source
indicator light
English
3. How to use
Filling with water
- First remove the kettle from the power base prior to filling with water.
- Turn the thermos lid in a counter-clockwise direction to open. Once water has been added,
close the lid by turning clockwise. replace the lid to prevent injuries from the steam of the
boiling water.
- The minimum amount of water must be no lower than the "MIN" line to avoid dry burning of
components. The maximum amount of water must be no higher than the "MAX" line to
avoid spillage of boiling water from the kettle.
1
Water Valve
1. Counter-clockwise direction to open
2. MAX water line
Boiling
- Plug the kettle power base into an electrical socket and place the kettle steadily on the
base.The kettle automatically connects to the power source, and the indicator light for
operation of the kettle turns on. The kettle is now in operation. After the water has boiled,
the kettle will automatically switch to Warming Mode, and the indicator light for boiling
handle
water will turn off, replaced by an indicator light for Warming Mode. The kettle is now in
Warming Mode. When the water temperature drops below 80 degrees, the kettle will
automatically begin to boil.
Power base
. 1 .
English
Cleaning
- A wet cloth may be used to wipe clean the kettle and power base. Do not immerse them
in water.
- Regularly inspect the filter for sediment. If sediment is found, rinse clean with water or use
a soft brush to wipe clean (do not use metal brushes). This appliance cannot be placed in
a dish washer.
- Do not use strongly corrosive cleaners to clean the kettle.
Periodic removal of sediment
- Calcium oxide is a naturally occurring calcium sediment that forms when water is heated.
It often sticks to heating elements, but is not dangerous to human health. However, if
ingested with drinking water, the taste can be unpleasant. Therefore, it is necessary to
2
periodically remove sediment.
- Under normal circumstances, sediment removal may be done 2 to 6 times per year.
3
- If boiling times are significantly longer than usual, or if the kettle quickly cuts power after
boiling, this is a good sign that sediment needs to be removed.
- Use vinegar and water in a 1:2 ratio poured into the kettle to its highest (MAX level)
position, then press the power switch on and allow the kettle to boil. Allow the solution to
remain in the kettle for 2 hours, then pour it out. Use clean water to rinse out the interior of
the kettle.
Maintenance
- When not in use, place the cleaned kettle in a dry, well-ventilated location.
3. MIN water line
Note:
For first usage, the kettle should be
filled to its highest point. Please
dispose of the first kettle full of boiled
water. To avoid scalding, do not
touch the kettle body while boiling.
4
5
4. Heating 5. Insulation
. 2 . . 3 .