Thermador VTN630 Installation Manual page 2

Integral Blower Installation
Suitable for the following hood models:
Hood Models
PH36GS, PH42GS, PH48GS, PH54GS,
PH60GS, PH30HS, PH36HS, PH48HS,
VCIB48JP, VCIB54JP, VCIN60RP, VCIB36JP,
VCIN36JP, VCIN48JP, VCIN54JP
inches (millimeters)
6⅞"
4⅛"
(175)
(105)
inches (millimeters)
8¼"
(210)
4⅛"
(175)
(105)
inches (millimeters)
18⅞" 18⅞" 18⅞"
(473) (473) (473)
8¼" 8¼" 8¼"
(208) (208) (208)
Integral Blower Model VTN1080 and VTN1090,
Blower
VTN1030
VTN630
VTN1080
VTN1090
8¼" (210)
8⅞"
(225)
2¼"
(57)
6¾"
(171)
25"
(635)
Integral Blower Model VTN1030
8⅞"
(225)
25" (635)
6⅞"
Integral Blower Model VTN630
10⅞" 10⅞" 10⅞"
(275) (275) (275)
13⅛" 13⅛" 13⅛"
(335) (335) (335)
VTN1090 shown
Installation Instructions
Integral Blower models are integrated into the ventilation
hood at the time of installation.
Refer to the Installation Manual for important safety
instructions. Use gloves when installing blower unit.
NOTE: The blower can be installed for horizontal or vertical
discharge only on HS and GS models.
1. The blower is attached to the hood using weld studs
provided on the mounting plate. Guide the motor
mounting plate over the studs.
2. Attach (4) nuts (included with hood) to the weld studs.
Tighten nuts to secure the blower to the hood.
3. Connect the blower's Molex plug connector to the
connector present inside the hood.
From Control Panel
Wiring the Hood with an Integral Blower
Weld Stud Locations
From Blower
English