Advertisement
5. If the indicator of the wireless charger is in quick flash mode, it indicates that the wireless charger is in
abnormally alarmed condition or that foreign objects such as metal are placed on the wireless charging
transmitter.
( For example: ①The transmitter coil and the receiver coil are not in good position; ②transmitter or receiver is
abnormal, etc.)
Note: At present, Samsung support the function of the full charging feedback, feedback as above, the rest of the
phone with full charging while wireless charging transmitter will not be prompted.
Mobile phone charging mode
1. Ensure that the wireless charger is connected to the power supply.
2. When the mobile phone is charged flat , the wireless charging transmitter need not be installed on the base.
When the mobile phone is horizontally or vertically charged, please install the base according to the Using Guide.
3. When Power on, the two white indicator of wireless charger will shortly flashing and off, the product is in
standby mode.
4. Put the mobile phone with wireless charging function on the wireless charger center, when charging , the
indicator will keep white light on.
5. If the phone does not display charging, please move your mobile phone location.
Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Attentions
1、Please do not crush or collision;
2、Please do not disassemble, dispose into fire or water, to avoid short-circuit and leakage.
Advertisement
