Table of Contents
Advertisement
Setting the Cur rent Channel
The current Channel is always indicat-
ed in the Channel window of the dis-
play (except when All or Bank buttons
are held down).The transmitter remains
set to the same Channel until a different
Channel is selected. To change the cur-
rent Channel, press the Channel up or
down buttons.
Setting the Active Channels
A Channel must be be made active
in order for it to respond to the var-
ious commands. You can tell if a
Channel is active by looking at the
bargraph and F-Value display areas
as you scroll through the Channels.
The absence of these displays indi-
cates the Channel is not active. To
make the current Channel active,
press the On button. To make the
current Channel inactive, press the
Off button.To make all the Channels
a c t i ve or inactive simu l t a n e o u s ly,
hold down the All button while
pressing the On or Off buttons.
Visual Verification
When an active channel is selected
or sent data, the model lamp on the
associated light unit will blink once
to verify it is receiving data and to
s h ow you which unit is being
addressed (unless the modeling lamp
is in Off Mode ).The LED light on
the associated re c e i ver will also
blink. This feature can help alleviate
the need to remember which lights
are set to which Channel numbers.
By simply scrolling through the
Channels while watching a particular
light unit until you see it blink, you
can identify which Channel it is set
to.
Refresh All Settings
Every time the ALL button is pressed,
all settings for all active Channels in the
selected Bank are resent.Thus you may
be certain that the settings shown on the
transmitter display have been received by
all the receivers by simply pressing the
ALL button and observing the light
units. All the modeling lamps (unless
turned off) should blink to acknowledge
they have received the current data.All
the active receiver LED lights should also
blink. To further verify the system, after
you press the ALL button, press the
FIRE button. This should fire all of the
lights. If either of these tests fail to pro-
vide the expected response you should
take steps to determine why a particular
receiver is not responding.
Setting Model Lamp Modes
1. Setting the model lamp mode for
the curre n t ly selected Channel is
achieved by operating the MODEL icon
b u t t o n . The M o d e l icon will cycle
t h rough the three possible modes:
OFF (icon black), ON (icon white) and
Proportional to Flash (icon half black,
half white).
2 . P ressing the A L L button while
scrolling through the three states of the
page 5
Advertisement
Table of Contents
