Warranty - White Lightning RadioRemote One Operating Instructions Manual

C h e c k : If camera sync cord has
reversible connections, t ry reve r s i n g
them. If using a hotshoe adaptor, make
sure the cord comes out the back end of
the camera,not the front. Try unplugging
sync cord from camera and momentarily
short the sync cord contacts together
with a metal object (this should fire the
system) if so, check camera and hotshoe,
if not,either the sync cord or the trans-
mitter have a defect.
Problem:Receiver won't work with another
brand of flash.
Check: Make sure the flash unit's sync
voltage is less than 50 volts.See Caution
on Page 1.
Problem:White Lightning modeling lights don't
blink when I send data.
Check: Modeling lamps will not blink if
they are in Off Mode.
Problem:Receiver LED blinks when I send
data,but flash unit doesn't respond.
C h e c k : Is flash unit connected to
Receiver? If so, try another connecting
cord,or try another flash unit.

Warranty

The RadioRemote One System carries
a 2 year factory warranty covering parts
and labor on manufacturing defects. See
our website for additional shipping instruc-
tions.
The obligations of Paul C. Buff, Inc. is
limited to repair or replacement only, and
no other warranty is expressed or implied.
C a u t i o n : Changes or modifications
made to the equipment, not expressly
approved by the
void the users authority to operate the
equipment.
Note: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. This equipment
generates,uses and can radiate radio fre-
quency energy and, if not installed and
used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interfer-
ence to radio or television reception,
which can be determined by turning the
equipment off and on, the user is
encouraged to try to correct the inter-
ference by one or more of the following
measures:
-- Reorient or relocate the receiving
antenna.
-- Increase the separation between the
equipment and receiver.
-- Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced
radio/TV technician for help.
page 10
manufacturer could