O3 Pure G3 User Manual page 4

G3 Eco Laundry System User Manual
Page 3
Please Visit www.o3pure.com
Installation Continued
Turn OFF your homes cold water faucet located near your washing ma-
chine. Turn your washing machine's setting to "COLD" water only and
run the machine for a moment to help remove excess water from the
cold water hose. Note: Some washing machines mix hot water with cold
water to ensure a minimum water temperature so you may not see the
water flow stop. Running the washing machine for a few seconds should
be adequate.
Remove your existing hose from the cold water faucet but keep the
hose attached to your washing machine. Connect your existing hose to
the area marked water "Outlet" on the Eco-laundry G3. Do NOT over
tighten. Make sure that there is a secure fit. Note: Make sure the hose
is in a good and functional condition. Replace the hose if it appears to
be worn out.
Attach the hose included with the Eco-laundry G3 to the area marked
water "Inlet" on the unit. Attach the other end to the cold water faucet.
Tighten both ends of the hose but do not over tighten them.
Slowly turn your cold water faucet back on. Make sure that there isn't
any leaking from any of the hoses.
Plug in the DC adapter to the Eco-laundry G3 unit and then plug it
into the outlet. It is now installed for operation. The Eco-laundry G3 is
automatic and will turn on when the water flows through it. A blue light
will appear only when water is flowing through the unit. Finally, run the
wash cycle on your washing machine two to three times before adding
any laundry. This helps remove all detergent buildup accumulated in the
machine.