Maintenance And Repair; Storage And Transportation; Troubleshooting - Challenge FB510 Original Instruction Manual

Maintenance and Repair

Maintenance and Repair
WARNING! Always switch the product off, unplug from the power socket and let the product cool
down before performing inspection, maintenance and cleaning work!
- After every use wipe the machine with a slight damp cloth. Do not clean the machine using a high-
pressure water jet.
- Clean the high-pressure jet nozzle.
The pressure washer is equipped with a water filter to protect the pump. If the filter is not kept clean,
the water flow to the machine will be restricted and the pump may be damaged.
To clean water filter, remove inlet adapter and get the filter out.
− Rinse filter until it is free of debris and blockage.
− Replace the filter and inlet adapter.
Clearing of the Lime scale
From periods of time, water lime scale may build up on your lance outlet, use the nozzle cleaning pin
to clean this away.

Storage and Transportation

Storing
Frost can damage your pressure washer that has not been completely emptied of water. The machine
should be stored in a frost free room. Do not kink high pressure hose.
Customer Helpline 01904 727508
16
www.coreservice.co.uk

Troubleshooting

General Troubleshooting
WARNING!
- Only perform the steps described within these instructions! All further inspection, maintenance and
repair work must be performed by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!
- Always turn off the machine and remove the plug before making any adjustment.
Problem Possible cause
1. No power - Check the plug socket, cable,
line and plug.
- Any of the parts are defective,
such as On/Off switch / motor
etc.
2. The high pressure washer - Power cable is damaged.
operates intermittently.
- Internal loose electrical
connection.
- On/Off switch defective (please
contact service agent).
3. No or only little pressure is - Check if there is any air in the
built up system.
- Check all inlet pipes leading to
the pump for leaks or the hose is
blocked or there is a kink in the
pipe
- Check the setting on the hand-
held spray gun.
4. Pressure varieties - Check the high pressure jet
nozzle
- Check the water inlet pressure.
5. Machine is leaking. Machine is leaking
6.Engine is running but no You might have air locked in the
pressure is build up hose.
Customer Helpline 01904 727508
www.coreservice.co.uk
Solution
- Connect to mains socket.
- Check by a specialist
electrician.
Check by a specialist electrician.
- If so, please ventilate the
machine! Run the machine
without the highpressure
hose connected until water
starts leaking without bubbles.
Reattach the high-pressure
hose.
- Check by a specialist
electrician
- Follow the Operation part
again.
If blocked, clean it with pin.
Please contact the service
agent.
Turn off machine, disconnect
hose, run water through and
connect again. If the problem
continues --then please contact
the customer helpline.
17